luvsecretlingerie Heavy Duty 26 Double Steel Boned Waist Training Overbust Tight Shaper Corset #9974
Fabric type: WoolCare instructions: Dry Clean OnlyOrigin: ImportedIMPORTANT: Follow the steps below to choose the correct size. You must check your torso length to ensure it is not too long or too short. Once you've confirmed the corset length fits, next, you must measure your bust, waist, and hips measurements.To choose your corset size, first, use your waist measurement. For a 24-inch waist, an XXS/20-inch corset is suggested (4-inch reduction). Next, check your overbust and hip measurements against the specified range. (Determine if the corset side length reaches your upper or widest hips, and use those measurements accordingly.) For example, if your overbust is 27-31 inches and hips are 31-35 inches, this size is correct.Heavy Duty Double Steel Boned Corset for flawless hourglass figure. This corset can draw in your waist and flatten your tummy & suitable for Tight-Lacing, Shaping and Waist Training. This corset also provide solid support to your lumbar, middle and lower back. It can also help with posture correction if wearing it during work.Corset Exterior- Wool, Corset Interior- Cotton with waist tape, Fasten at the front with Rust Free Eyelet, Ties up at the back with powerful Corset Cord Lacing and 4 Garter Tabs for you to attach the Garter set, Total of 26 Steel Bones, 2 Strong Steel Busk Bones (1 inch wide each) at the front, 4 Rigid Steel Plates, and 20 Spiral/Flexible Steel Bones around the corset13.7 (35 CM) length for the front (measure from centre), 14.9 (38 CM) length for the front (measure from overbust), 11.4 (29 CM) length for the side, 13.7 (35 CM) length for the back, 5” (12.7 CM) length for modesty panel at the back